コンテンツにスキップ
STAGING SERVER
DEVELOPMENT SERVER

Hardware Installation (Stereo ace)#

This topic explains how to install a Basler Stereo ace camera.

The illustrations used show the STA-100-547C-082609W camera model. However, the information in this topic applies to all models.

概要#

カメラを取り付ける前に、次の点を確認してください。

  • You have read and understood the safety instructions.
  • The pylon Software Suite and the pylon Supplementary Package for Stereo ace have been installed on your computer.
  • You have all necessary accessories at hand (mounting bracket, cables for connecting the cameras to the projector, GigE cables, power supply, etc.).

インストール#

Mounting the Camera

To avoid damaging the camera, only mount the camera using the mounting points provided (M5 and 1/4" threads). These are located at the top and bottom of the camera.

Mounting Threads

カメラを取り付けるには:

  1. Connect the right and the left camera to the projector using the cables provided in the package.
    Connecting the Cameras to the Projector
  2. Plug Ethernet cables into the right and the left camera. (Ethernet cables are not included.)
  3. Connect the RJ45 connector of the GigE cables to the Ethernet ports of your computer or network switch.
  4. Connect the M12 8-pin plug of the power supply cable to the M12 power connector on the back of the camera. Tighten the connector to the recommended torque (60 Ncm).
    Connecting the Projector to Power
  5. Plug the AC power plug of the power supply into a mains socket.

When the Status LEDs of the cameras and the Power LED of the projector are solid green, the Stereo ace camera is ready for use. For more information about LED states, see the "LED States" section of your camera model topic.

注意 – カメラの電源ケーブルを不適切に差し込んだり抜いたりすると、カメラが損傷するおそれがあります。

To avoid switch-on surges damaging the camera, only plug in or unplug the power cable from the camera's power connector when the power supply is switched off.

次のステップ#

ネットワーク設定を続行します。