GigE Interface Card#
The interface cards are tested for seamless operation with Basler GigE cameras and the Basler pylon Software Suite resulting in enhanced performance and stability.
一般仕様#
仕様 | |
---|---|
オペレーティングシステム | Ubuntu 18.04 LTS以降で使用されるWindows 10/11 Linuxカーネル安定版 |
The following tables include the names of the available Basler GigE Interface Cards, their compliances with Base-T transmission rate categories, the kinds of brackets present, and the required unoccupied PCIe slots on the computer's motherboard.
モデル | GigE, 1 Port | GigE, 2 Port | GigE, 4 Port | 5GigE, 4 Port | 10GigE, 1 Port |
---|---|---|---|---|---|
10 Base‑T | x | x | x | x | x |
100 Base‑T | x | x | x | x | x |
1000 Base‑T | x | x | x | x | x |
2.5G Base‑T | x | x | |||
5G Base‑T | x | x | |||
10G Base‑T | x | ||||
Low Profile Bracket | x | x | x | ||
PoE | |||||
PCIeスロット要件 | ≥2.1x1 | ≥2.1x2 | ≥2.1x4 | ≥2.1x4 | ≥2.1x1 |
モデル | GigE, 1 Port PoE | GigE, 2 Port PoE | GigE, 4 Port PoE | 5GigE, 4 Port PoE+ |
---|---|---|---|---|
10 Base‑T | x | x | x | x |
100 Base‑T | x | x | x | x |
1000 Base‑T | x | x | x | x |
2.5G Base‑T | x | |||
5G Base‑T | x | |||
10G Base‑T | ||||
Low Profile Bracket | x | x | ||
PoE | x | x | x | x |
PCIeスロット要件 | ≥2.1x1 | ≥2.1x2 | ≥2.1x4 | ≥2.1x4 |
The PoE GigE interface cards support the IEEE 802.3at, 2009 PoE standard (25.5 W per port).
The PoE interface cards listed in the tables above receive power via the PCIe slots.
For 1-Port and 2-Port PoE cards, the power is supplied over PCIe only.
For 4-Port 1GigE and 5GigE PoE cards, the power is also supplied over PCIe. In addition, for the 4-Port 1GigE and 5GigE PoE interface cards, the power can also be supplied via a 4-pin 5.25" Molex receptacle of the Molex 8981 series (AUX connector). Usually, PCIe delivers enough power for Basler cameras. When using devices that require high power, ensure that PCIe delivers enough power. For the 4-Port 1GigE and 5GigE PoE interface cards, the AUX connector can be used instead of PCIe if PCIe doesn't provide enough power.
最大ケーブル長#
Baslerは、Baslerインターフェースカードとカメラを接続するために特別に設計された高品質のケーブルとプラグをご用意しています。
次の表に示すように、最大指定ケーブル長は、転送速度とシールドカテゴリーによって異なります。Baslerは、指定ケーブル長を超えないようにすることをおすすめします。
転送速度 | 最大ケーブル長(Cat 5e) | 最大ケーブル長(Cat 6) | 最大ケーブル長(Cat 6a) | 最大ケーブル長(Cat 7) |
---|---|---|---|---|
1000Base-T | 100 m | 100 m | 100 m | 100 m |
2.5GBase-T | 約75ma | 約100ma | 100 m | 100 m |
5GBase-T | - | 約50ma | 100 m | 100 m |
10GBase-T | - | 約30ma | 約55m | 100 m |
-
指定されていません。使用を検討する場合は、事前にこれらのケーブル長を試験してください。
Basler GigE Interface Cards (without PoE)#
- GigEインターフェースカード、1ポート
- GigEインターフェースカード、2ポート
- GigEインターフェースカード、4ポート
- 5GigE Interface Card, 4 Port
- 10GigEインターフェースカード、1ポート